Ryandor.com

How to copy the Ilshenar Map to the Brittania map (map2.mul to map0.mul)

Requirements:
UOCopy (latest release*)
MulTool or WorldForge
map0.mul (from any UO CD)
statics0.mul (from any UO CD)
staidx0.mul (from any UO CD)
map2.mul (from any UO:3D CD or later)
statics2.mul (from any UO:3D CD or later)
staidx2.mul (from any UO:3D CD or later)

*If you've not downloaded this since July, redownload it. Older versions do NOT support this)

This is fairly easy. Copy everything into it's own directory. For this example I'll put everything into the directory c:/mapmove.

Fire up WorldForge or Multool.
You'll should clear the map and statics so you are not left with anything from the old map. Once done, proceed:

Run UOCopy.
Fill in the blocks as listed:

Source:
staidx0.mul: c:/mapmove/staidx2.mul
statics0.mul: c:/mapmove/statics2.mul
map0.mul: c:/mapmove/map2.mul

Destination:
items.wsc: c:/mapmove/items.wsc
map0.mul: c:/mapmove/map0.mul

Copy Rectangle:
Min X: 0 Min Y: 0
Max X: 2304 Max Y: 1600
Off X: 2000 Off Y: 1200
Off Z: 0

These numbers will approximately center the Ilshenar on the map0.mul
Hit "Copy Map". Wait for it to finish.
Hit "Copy Statics". Wait for it to finish.

Then using MulTool or WorldForge, freeze the items.wsc into the statics files.
Copy the map0, statics0, and staidx0 muls into your client directory.
If everything was successful, you now have a full Ilshenar map usable as a main map.