Ryandor.com
http://www.ryandor.com/forum/

I/O error 32???
http://www.ryandor.com/forum/viewtopic.php?f=2&t=2847
Page 1 of 1

Author:  Caldorean [ Thu May 11, 2006 3:16 pm ]
Post subject:  I/O error 32???

I keep getting this error when I try to edit my map. I know the map is in the location and I know it is a valid map. What I don't know is what to do to correct it :) If you folks can help I would appreciate it :)

Author:  Sydius [ Thu May 11, 2006 3:27 pm ]
Post subject: 

Is the client or any other map editing/viewing program running?

Author:  Caldorean [ Thu May 11, 2006 4:58 pm ]
Post subject: 

No. I have UO installed twice. Once on c drive and again on G. I use C: for my client and G: for my editing. Besides that I am connected through UOGateway using a patch anyways so it shouldn't be using them client side. I can open WF just fine and my statics boxes are green pointing to G:. when I goto edit map I get the I/O error 32 but both those boxes are green as well. If I move the map0.mul out of the folder it will open just fine buth the map box is red. Once I key in the location again it say it cannot find the file though the box turns green again. About 10 seconds later the I.O error pops up again... I hope I am being descriptive enough as I have tried everything I can think of including reinstalling Worldforge

Author:  Caldorean [ Thu May 11, 2006 6:12 pm ]
Post subject: 

Okay for some reason it must have mattered because as soon as I closed my client it opened right up. It seems like I didn't have to do it that way before though. Seems like I bounced around and found the bad transitions and flipped over to world forge and made the change... then moved the map over when I was done... Ohh well... It is working now but not at the same time as UO. Thanks for the help mate.

Author:  Kronos [ Thu May 11, 2006 8:53 pm ]
Post subject: 

when something is using the files that its trying to open it gets errors.

Author:  HellRazor [ Fri May 12, 2006 2:16 am ]
Post subject: 

Caldorean wrote:
No. I have UO installed twice. Once on c drive and again on G. I use C: for my client and G: for my editing. Besides that I am connected through UOGateway using a patch anyways so it shouldn't be using them client side. I can open WF just fine and my statics boxes are green pointing to G:. when I goto edit map I get the I/O error 32 but both those boxes are green as well. If I move the map0.mul out of the folder it will open just fine buth the map box is red. Once I key in the location again it say it cannot find the file though the box turns green again. About 10 seconds later the I.O error pops up again... I hope I am being descriptive enough as I have tried everything I can think of including reinstalling Worldforge


You do realize that unless you change the registry entries for UO that the client will always read the MUL files from the last directory you installed UO to? No matter where the client is located, it will always read from the path in the registry.

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/